| CAID: MIPS-900 | Title: Start-up Activities, Si | |
| System: MIPS | Principal: dmkelly | Deputy: cengelbracht |
| Objective: | Prepare the MIPS Si array for science
operations
by
executing a standard set of MIPS
turn-on tasks. |
| Description: | 1) Turn on power to the combined electronics
2) Transition from OFF to MIPS_OBSERVE
3) Perform thermal anneals on the Si array
5) Point the telescope to the first desired
target
6) Before beginning the next IOC task, wait
as
necessary until
30 minutes has elapsed since the CE
power-on
|
| Day: 5.9194444444438 | Suggested Order: | ||
| Must be preceded by these activities (list by CAID): MIPS-015 | |||
| Place in Schedule: At the start of each IOC campaign in which Si but not Ge measurements are planned | |||
| Priority: Necessary | |||
Conditions | |||
| Maximum telescope temperature: | 300 K | ||
| Minimum telescope temperature: | 5.5 K | ||
| Should activity be repeated if focus changes? | No Repeat if focus changes by 0 mm | ||
| Maximum absolute pointing uncertainty: | 3600 arcsec (1 sigma radial) | ||
| Maximum precision offset uncertainty: | 3600 arcsec (1 sigma radial) | ||
| Observatory configuration: | standard | ||
| Go/No Go criteria: | Successful completion of MIPS-015 | ||
Duration: 30 minutes
| | Real time downlink:
No | | |||
| Data Volume (uncompressed): 5 Mbits | |||
| List Blocks, AORs, SERs, IERs, or unique sequences required (uplink): Power-on blocks, 24um thermal anneal IER | |||
| List Analysis tools required (downlink): A spreadsheet for looking at the thermal diagnostic data | |||
| Estimate of data turn around: 24 hours | |||
| Description: The thermal anneal temperatures will be plotted and examined | |||
| Can proceed in parallel with other activity: No | |||
| Must outcome be confirmed before next activity: No | |||
| Method of Confirmation: Visual inspection of the temperature telemetry | |||
| Success criteria: The thermal anneal will be considered successful if the anneal heater turns on and off as expected and if the array temperature changes as expected based on ground-based testing. | |||
| Contingency plan: If the anneal heater fails to operate, we will need to switch to using bias boost or photon flood anneals. | |||
Comments | |||
| References: | |||
|
Additional Comments:
To be executed at the beginning of every campaign that uses only the Si detectors. | |||
| This activity last updated: 7/2/2002 2:50:08 PM | |||